Tool designed for replacing rear axle bonded rubber mounting bushing(s) while on car without need for removing rear axle assembly For use on Bora 1.4/1.6/1.8/2.0 and 1.9D(2001 to 2003) Tool used for removal and installation For use on Audi A3 VW Golf IV Product Features: Blackened oxide finish to resist corrosion Bearing assisted force nut for ease and longevity of tool Tool allows the bush to be fitted quickly and easily without causing damage while axle still on vehicle For use on Audi A3; VW Golf IV; Bora 1.4/1.6/1.8/2.0 and 1.9D(2001~2003) Recommended Instructions of use: Step 1: Securely support the vehicle with jack stands or frame lift, then remove the rear wheels per factory manual Step 2: Remove both front mounting bolts from the rear axle mounting bracket Step 3: Pull the front end of the trailing arm down the mounting bracket and wedge into position, using a solid object between the arm end and the underside of the vehicle. Step 4: Mark the exact position in the arm of the rubber mounting Step 5: Remove the old mounting bush from the trailing arm Step 6: Lubricate the screw threads of the tool Step 7: Align the Y mark on the new bush with the mark on the axle trailing arm Step 8: Assemble the bush suspension tool and insert the new bonded mounting into position, adapter is lipped and designed to sit flush against the trailing arm Step 9: With a 24mm socket on ratchet slowly turn the thrust bearing to pull the new mounting into the rear axl Step 10. Re-assemble and Repeat steps 3-9 for the other side