Works great for now, lets see how long it lasts>

When my lights went and the bulb was fine, it took a lot of detective work to figure out what had gone wrong. Eventually located the fault as the transformer. Could not get a like for like replacement, but this was the right spec and works perfectly

Very happy with this item, does exactly what it was bought to do; extremely happy with the pricing!

Very easy to install. I bought this because it was dimmable, and it is, but!!!! What I wasn't expecting was a disco. It finds it hard to maintain a set voltage and just goes up and down, it will shoot up to full power and then go down to minimum. I've tried three other switches just in case, but still have the same problem. Not good overall.

Useful for replacing a faulty unit that came with under cabinet lighting. Simple job to replace.

Used this Transformer to replace one that had 'died'. I was fairly confident it was the Transformer as I had changed the LED light bulb for a new one and it didn't work, so it had to be the transformer. I had no AvoMeter so fault finding by trial and error! I isolated the supply at the Junction Box (Upper floor lights), took a photo of the internal connections of the defective unit using my mobile phone. Removed the defective transformer and replaced with the new Knightsbridge unit and reconnected in the reverse order the LED light fitting tails etc. Job done - switched on at Junction Box - all good and LED light now works.

Two transformers bought. Both are dead within barely a month.

Wiring and lampholders all checked and in order. There are two other lights on the same circuit which are still working.

Really not good.

This transformer is L 120mm x W 30mm x H23mm in size, has a thermal fuse for heat protection has an input of 240V with a 12V output and a maximum of 60W and a cable supplied. I bought this as a replacement for my ceiling light which has G4 halogen bulbs.Good product and easy to install.This is a non biased review of this item

This package was exactly what i needed for my ceiling lights which were playing up. The transformers (I needed two) were well boxed and felt like a quality product. It took me 20 minutes to change and they worked immediately. Another job off the wife's list. I would recommend this product and company.

This does the job but I should have bought one without wires. Because they are pre-attached (and not obvious how to remove them) it was necessary to connect to the mains using a connector block. After this I've bought ones to which mains and 12V wires can be attached.It is great value and, like I've mentioned, it works so no complaints about the functioning. But be sure you need to wires already attached.