Ideal for bathroom, shower and WC. At the push of a button you receive a sufficient amount of soap.The dispenser doe not drip and can be refilled. You can always check how much soap is leftEasy to clean.Ideal for bathroom, shower and WC. The soap dispenser is suitable for liquid soap, hair conditioner, shower gels, shampoo and lotion.Caution! Please observe that a minimum clearance of 20 cm must be given between the bottom side of the soap dispenser and the washbasin (or other objects), otherwise the infrared sensor will not work! Fixing the soap dispenser with adhesive tape and silicone: Caution! Silicone not included.1. The mounting surface must be smooth, clean and grease-free. 2. Stick the double-sided adhesive tape to the back of the soap dispenser and pull the protective film off the adhesive section. 3. Apply the silicone in a wave-like pattern to the back of the soap dispenser. 4. Stick the soap dispenser to the wall in the required position. Caution! Do not apply any silicone to the adhesive surface of the adhesive tape, so that the silicone does not reduce the adhesive strength of the soap dispenser. The silicone must be allowed to dry for Fixing the soap dispenser with screws and dowels: 1. Hold the drilling template against the wall in the required position and mark the drill holes. 2. Drill the holes. 3. Mount the soap dispenser to the wall using the supplied screws and dowels. Instructions for the use of the soap dispenser: 1. Open the soap dispenser at the side using the supplied key and fold down the lid. 2. Take the lid off the chamber and fill with the desired liquid. 3. Then close the soap dispenser again in reverse order. 4. Using the enclosed labels, you can indicate below the level display which liquid is in which chamber. 5. Push the slide switch on the right of the soap dispenser to ?ON?, so that the soap dispenser with the infrared sensor is activated. 6. Actuate the soap dispenser several times after filling with the desired liquids to allow the air to escape. Caution! Before putting the soap dispenser into operation, fill it with approx. 100 ml water and rinse it thoroughly so the pump can be freed of any impurities. The liquid soap can then be filled in. Capacity: 650 ml Changing the batteries: 1. Open the soap dispenser at the side using the supplied key and fold down the lid. 2. Take the lid off the battery compartment and insert 4 x 1.5 V batteries, type AA. 3. Then close the lid of the battery compartment and the soap dispenser again. Caution! Batteries not enclosed!Wenko is a 50 years old family owned business from Germany, with an assortment of over 4000 bathroom and household accessories. All of them have one aim: "To make the customers' life easier". That is why the company slogan is: Wenko - the better idea.Box Containsdouble sided adhesive tapeScrews and dowelsSoap dispenderKey